• Contact Us RSS Feed


    If you have any questions or comments for the Kitchener Waterloo Aquarium Society, you can contact us through regular postal mail or email. If you are looking for help with a fish or aquarium please visit the KWAS community forums by clicking on the Forum button above.

    Kitchener Waterloo Aquarium Society
    P.O. Box 38037
    256 King Street North
    Waterloo, Ontario
    Canada N2J 4T9

    Email
    Kitchener Waterloo Aquarium Society here
    KWAS Executive & Board of Directors here

  • Next KWAS Meeting

    Tuesday February 7, 2012 @ 7:30pm is the next KWAS general meeting. Our doors open at 7pm. Veronique LaPage from the University of Guelph will visit the club again to discuss one of her passions Syngnathids (Seahorses).

  • Recent Forum Posts

    t_rex3

    I'm afraid I have a real juvenile question.........pun intended

    I have a lot of juvenile pleco's. They range anywhere from approx. 1 month

    Juvie Pleco's .. Long fin or Regular fin that is my question :-)

    t_rex3 February 4th, 2012, 03:44 PM Go to last post
    filipem

    water flow and o2 are not an issue he runs a large air stone 24/7 and the tank is filtered with a ehiem 2217 and a fluval fx5

    I know... that's

    weird algae growth please help ID

    filipem February 4th, 2012, 03:08 PM Go to last post
    arty g

    I have had a few heater failures over the past 6 months or so. This is unusual in my experience, but may be more common than I know. But now I need

    Heater recommendations

    arty g February 4th, 2012, 03:03 PM Go to last post
    arty g

    Here we go again. The CroMs laid eggs 3 more times since the last post, but nothing viable resulted. I have since separated the angels into males and

    Angel re-housing advice

    arty g February 4th, 2012, 02:56 PM Go to last post
    arty g

    Erythromycin definitely works, but is expensive and dangerous. As you noted, the die-off can get toxic as the bacteria / algae growth dies.
    Can

    weird algae growth please help ID

    arty g February 4th, 2012, 02:48 PM Go to last post